3D Printer M7 Thread MK10 Nozzle Cleaning Kit 1.75MM Filament

3D Printer M7 Thread MK10 Nozzle Cleaning Kit 1.75MM Filament .4mm Nozzle and De-Clogging Bits 0.4mm (4qty) + 3.5" Pin-Vise Poor Print Quality Solution
- Will clear nozzles and produce finer prints
- Shipped in protective plastic case
- M7 thread MK10 printer nozzle 0.4mm
- De-clogging bits (4qty) .4mm
- 3.5" comfortably held nozzle cleaning pin-vise tool
Kit includes: Nozzles/Bits/Pin-Vise

1) MK10 Nozzle for 1.75MM
Material: Brass
Filament inlet: 1.75mm
Fit for: Wanhao Dupicator D4/I3/Dremel and various Makerbot 3D Printers

Please verify that these are the nozzle for you printer. M7 thread MK10

(1qty)

.4mm

2) Custom bit holding Pin-Vise

Fits 2.0mm and 3.75mm shank bits

3) Nozzle clearing drill bits:

(4qty) 0.4mm

Cleaning Information:

These drill bits are of the highest quality you can find but are delicate by nature. Only with the bits can you clear clogs and clean out nozzles of any size. We have bits of larger sizes if you should need them.

The delicate nature of the bits means you must be very careful when using them. Do NOT apply side pressure. North/South movements only. You can clear a cold nozzle if done carefully, but it is HIGHLY recommended that you heat the nozzle first. You can leave it on the printer, or take it off. You can even heat it with a blow-torch after removing, but that will blacken the nozzle. Regardless, the nozzle should be fastened or clamped down if removed to avoid movement. Once you get the nozzle firmly set, use the pin-vise to insert the bit slowly. Spin the bit a few rotations and slowly pull it out. The nature of the bit curves will pull out any clogs and you are back in business!!

Country USA
Brand Daewon Industries
Manufacturer Daewon Industries
Binding Misc.
ItemPartNumber DAE-4mmKit-MK10
UPCs 700424792535
EANs 0700424792535
ReleaseDate 0000-00-00

Country	USA
Brand	Daewon Industries
Manufacturer	Daewon Industries
Binding	Misc.
ItemPartNumber	DAE-4mmKit-MK10
UPCs	700424792535
EANs	0700424792535
ReleaseDate	0000-00-00

3D Printer M7 Thread MK10 Nozzle Cleaning Kit 1.75MM Filament .4mm Nozzle and De-Clogging Bits 0.4mm (4qty) + 3.5" Pin-Vise Poor Print Quality Solution

Customers who purchased this also purchased....