Peachtree Woodworking Supply Miter T-Bar for Jigs Fixtures

Peachtree Woodworking Supply Miter T-Bar for Jigs Fixtures Sleds Router Tables and General Woodworking - 46 inch
- When building sleds, jigs or fixtures for your woodworking projects that help keep your fixtures from moving or to help your sleds and jigs slide through a track, the Miter T Bar may just be the perfect solution. The Miter T Bar does this bit fitting neatly into most standard miter slots that measure ¾” x 3/8”. The aluminum bar can be used to slide your sleds or it can be used to lock fixtures like featherboards (when cut into smaller length pieces) in place in a miter slot.
- The T-bar is made in the USA from a solid piece of extruded aluminum and can be cut into sections and drilled as needed. Typical uses for the T-bar are fixtures like featherboards where the featherboard needs to be kept stationary to apply consistent pressure. The T-bar also works great for sleds and other sliding fixtures like cutoff sleds on a table saw or coping sleds on a router table.
- When mounting the Miter T-Bar it is a good idea to keep in mind that the “T” on the bottom of the track is approx. 1/8” tall, which is just enough to clear the t-slot on most miter slots. If mounted directly to platform for a sled, the tabs may catch and prevent the sled from sliding freely. To remedy this, we recommend using washers between the mounted track and the platform to allow the sled to slide as desired.
- The Miter T-Bar can also be mounted upside down by cutting a dado slot into your sled platform that is the same depth as the T on the Miter T-Bar. The Miter T-Bar will then act much more like a standard solid miter bar. Using this type of flush mount may work better in certain situations when compared to the traditional method.
- When we decided to start manufacturing aluminum tracks many years ago (well over 20 years), we thought that it was very important to do our best to keep the manufacturing process here in the United States. We are proud to say that even after 20 years, we manufacture all of our anodized aluminum track (including this Miter T Track) here in the USA. This helps our customers know that not only are they supporting the economy, but also receiving a high quality product.
The Miter T-Bar slides smoothly into the miter t slot groove on your table saw,router table,band saw or shaper. This gives you the ability to create jigs and fixtures of most any kind. You can create fixtures for your feather boards, stop blocks, hold downs and more. Not only does the T-Bar work for building fixtures , it will also slide into the miter T slot of most table saws for building all types of sliding sleds or table saw jigs. Our Miter T-bar is made 100% in the USA and come with full installation instructions.The Miter T- Bar measures appx. 48" (length is approximate and may slightly vary).
Country USA
Brand Peachtree Woodworking Supply
Manufacturer Peachtree Woodworking
Binding Misc.
ItemPartNumber PW1034
UPCs 810948012252
EANs 5915903721370
ReleaseDate 0000-00-00

Peachtree Woodworking Supply Miter T-Bar for Jigs Fixtures Sleds Router Tables and General Woodworking - 46 inch

Customers who purchased this also purchased...

You might also like...

Country	USA
Brand	Peachtree Woodworking Supply
Manufacturer	Peachtree Woodworking
Binding	Misc.
ItemPartNumber	PW1034
UPCs	810948012252
EANs	5915903721370
ReleaseDate	0000-00-00