AEM (30-3302) V2 Water/Methanol Injection Kit with Internal

AEM (30-3302) V2 Water/Methanol Injection Kit with Internal MAP Sensor
- Boost Dependent controller features on-board MAP sensor with large adjustment knobs, integrated plug for harness connection, integrated fuse, covered status light and test button for enhanced splash resistance and mounting tabs
- Wiring harness is terminated with a positive-lock connector on one end with color-coded wires to ease installation, power and ground wires for the pump and additional wire for optional on/off fluid solenoid
- Pump does not cycle on/off and provides quiet, smooth operation; it features robust construction including integral hose fittings, EPDM seals and a Santoprene diaphragm that provides consistent and reliable fluid delivery
- Precision-machined billet-aluminum injector with integral check valve; three interchangeable injector nozzles to cover a wide variety of HP levels (250cc/min, 500cc/min and 1,000cc/min); tank-less 35 PSI Boost dependent gas water/methanol system
Water/Methanol injection for gas engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation on forced induction and high compression naturally aspirated (NA) race engines. This allows racers to reliably increase boost and advance ignition timing-without using high-octane racing fuel-for power gains of up to 20 percent. AEM's Water/Methanol Injection Systems utilize the most robust hardware combined with more advanced features than any other comparably priced water/methanol system. The on-demand progressive controller in AEM's Boost Dependent tank-less Water/Methanol Injection kit bases injection flow on manifold pressure using an on-board MAP sensor (up to 35 PSI of boost) to ensure the proper amount of water/methanol injection at all points along an engine's power curve. The new controller design features large, turn-resistant knobs and larger numbering to easily set accurate start and full activation points, with covered status LED and test buttons for added splash resistance. A plug is integrated into the controller housing for mating to the redesigned wiring harness's positive-lock connector. The Boost Dependent controller housing has a molded-in, barbed nipple to accept a boost hose and a wiring legend on the back, integrated fuse and molded mounting tabs. AEM's Boost Dependent Water/Methanol Injection kit's wiring harness is terminated with a positive-lock connector on one end and has color-coded wires to ease installation. Both the power and ground wires for the pump are included in the harness which simplifies the wiring process and eliminates any chance of the pump accidentally activating from a short in the system. An additional wire is included for adding an optional on/off solenoid to stop fluid flow when the system is inactive.
Country USA
Brand AEM
Manufacturer AEM
Binding Automotive
ItemPartNumber 30-3302
Model 30-3302
Warranty 1 Year
Color No Color
ReleaseDate 2013-11-20
Size No Size
UnitCount 1
UPCs 840879022662
EANs 0840879022662

Country	USA
Brand	AEM
Manufacturer	AEM
Binding	Automotive
ItemPartNumber	30-3302
Model	30-3302
Warranty	1 Year
Color	No Color
ReleaseDate	2013-11-20
Size	No Size
UnitCount	1
UPCs	840879022662
EANs	0840879022662

AEM (30-3302) V2 Water/Methanol Injection Kit with Internal MAP Sensor

Customers who purchased this also purchased....