Alightings 5050 RGB 4 Pin LED Connectors Connect Strip to

Alightings 5050 RGB 4 Pin LED Connectors Connect Strip to Strip, Applicable for 10mm 4pin Standard Waterproof Strip Lights (Pack of 10)

NOTE: 1.Make sure your section of LED light strip is 10MM wide 5050 RGB STANDARD WATERPROOF LED Strip Light.
2 .If your strip are NON-WATERPROOF or NON-STANDARD WATERPROOF lights(too soft or too thin), pls use this item (ASIN:B01MU7FKUK)

Firmly bite the strip, no need to peel back the silicon cover
Updated version of LED strip connectors, assemble wire by yourself as needed, flexible to different project! No need to solder. Just clasp your prepared led strip section into the connector to get connected. Connect waterproof LED strip without removing surface coating silicon gel, compatible with 30-120 LEDs/M strip, made of flame retardant material, safely use. Support high current LED strip lights.

Installation Instructions:
1.Open the transparent cover of connector up to 90 degrees.
2.Peel off the 3M glue from the back of the strip light.
3.Insert the strip section to the END of strip side of connector,Â keep the lamp face up,and the tape is on the pin.
4.Close the transparent cap with a plier until it is fully seated on both sides of the bottom base.
Note: Make sure that the positive and negative electrodes on the light strips at both ends of the connector are corresponding.

Package Contents:
10pcs Strip to Wire Connectors
Country USA
Brand Alightings
Binding Tools & Home Improvement
ItemPartNumber SYNCHKG120493
Model SYNCHKG120493
UnitCount 10
UPCs 647336181142
EANs 0647336181142
ReleaseDate 0000-00-00

Country	USA
Brand	Alightings
Binding	Tools & Home Improvement
ItemPartNumber	SYNCHKG120493
Model	SYNCHKG120493
UnitCount	10
UPCs	647336181142
EANs	0647336181142
ReleaseDate	0000-00-00

Alightings 5050 RGB 4 Pin LED Connectors Connect Strip to Strip, Applicable for 10mm 4pin Standard Waterproof Strip Lights (Pack of 10)

You might also like...