Anvil Aqua Seal Waterproofer Bonding Primer #235 Acrylic Clear Penetrating Sealer (2 Gallon)

Anvil Aqua Seal Waterproofing Sealer is a fast drying, water clean-up, environmentally friendly, multipurpose penetrating sealer/primer for vertical surfaces. It may be applied as a stand-alone, clear sealer or top coated with elastomeric, latex or oil based coatings. The dried film is resistant to mildew for it contains agents which inhibit the growth of mildew on the surface of the sealer film and is also resistant to acids, and salts.

Aqua Seal provides a tough and flexible film with excellent scrub resistance. May be tinted with latex paint or stain. Mix with equal parts of latex paint for use as a primer. Mix with exterior latex paint to increase its weatherability. May also be used as a binder sealer by adding one gallon of Aqua Seal to five gallons of block filler.

USAGE: Aqua Seal protects and seals vertical surfaces of Brick, Stucco, Concrete, Grout, Stone, Plaster, Drywall, Adobe, Simulated Brick, Metal, Chalky Surfaces, Terra Cotta Roof Tiles, Asphalt Shingles, Aluminum & Vinyl Siding, Pottery and many other nonporous surfaces. Aqua Seal is designed for above grade use only and should not be used on applications exposed to hydrostatic water pressure. Elimination of cascading or ponding water must be addressed prior to Aqua Seal application.

RECOMMENDED PREPARATION: Remove all dirt, efflorescence, grease, oil, waxes, release agents and peeling pain. Two coats are required if used to waterproof bare vertical concrete.

APPLICATION: Covers 80-300 sq. ft. per gallon depending on surface porosity. For best results apply with a low-pressure garden sprayer or airless paint sprayer. Flood coat the surface liberally beginning at the top and allow Aqua Seal to run down the surface about 8 inches. For best waterproofing and sealing, back roll the wet coat to uniformly force the sealer into the surface.