Cable tester, TopOne Wire Tracker Tester RJ45 RJ11 Network Cable Tester Telephone Phone Wire Finder Ethernet LAN Line Finder Cat5 Cat6 with 2 Network Wire Stripper, Headphone, Toolkit Upgraded Version

1.Use as Circuit Tester

Connect two alligator clips to the ends of the wire to check if resistance exists. If yes, the wire could be a short or open circuit. You can use the Wire Tracker function to locate the problem.

2.Use as a Wire Tracer

By sending a signal down the wire being tested, you can trace the wire with the detector probe. An audible tone will increase in volume as the probe gets closer to the wire. Note:In a noisy environment, you can put on the headset and adjust it to a proper volume to avoid the interference.

3.Low Battery Capacity Indication 

Move the function selector switch of the emitter to the "SCAN"position,when the cell voltage is below 6.0V，the STATUS indicator and the VERIFY indicator of the emitter can flash at the same time.

4.Please Note:

- Please make sure that the wires you are going to test are in low-electricity or power-off condition ,for the maximum currents for emitter and receiver are 10mA and 30mA respectively.

- Please consult professionals for  technical guidance or contact seller if you have any question after reading the instructions;

- Please remove the battery when you don't use the device for a long time.

Product Specification:

1.Power specs:DC,9V laminated battery( included)

2.Max. operating current:Emitter ≤10mA; Receiver≤30mA

3.Signal transmission format: Multi-frequency pulse

4.Signal output level:8Vp-p

5.Maximum Signal transmission distance:3km

Package Includes:

1 * Emitter

1 * receiver

1 * earphone

1 * RJ11 adapter

1 * RJ45 adapter

1 * alligator clip adapter

1 * Toolkit

1 * User manual

2 * 9V Battery