Instrument Panel Bezel

Chrysler 300 2005-2007* * Wiring harness in this kit does not work on models with factory CanBus systems or radios (REF, REC, RAQ, RAK) & Boston Acoustic Systems. This is the complete kit that is needed to install a aftermarket Double Din radio into a Chrysler 300 with a Factory non Navigation radio installed. This entire set up includes the factory radio bezel IN BLACK!!! (part# WX57DX9AA), Double Din radio install trim kit, wiring harness and Antenna Adapter. Thus eliminating the time and hassle of buying four pieces separately. The Factory radio bezel (part# WX57DX9AA) is needed due to the fact that the opening or hole from the factory radio (with non factory navigation installed) is too small to install a aftermarket double din radio. So you must replace the whole trim piece. The bezel is BLACK!!! The Double din radio install trim kit is then needed to then reduce the factory radio bezel to the correct size of an aftermarket Double Din radio. This dash kit is designed specifically for your vehicle, it lines up with factory mounting to install and uninstall easily, in-case you decide to sell your vehicle it can go right back to factory. There are no modifications necessary. The harness will save you time and aggravation. To use it simply unplug your factory radio from the harness in the dash. On the aftermarket radio wire this in by matching up the colors. Our harness meets EIA color codes to take out the guess work. Then simply plug the aftermarket radio back in to the factory plug in the vehicle. No cut wires, if you sell your vehicle simply unplug the aftermarket radio and re-plug in the factory radio. The antenna adapter is used to adapt the factory antenna end to the standard Motorola male end need to plug in to your new aftermarket radio. This plug may not work if you have installed an aftermarket antenna, as most of those do not require adaptation. There are no modifications necessary.