Color Enhancer Sealer for All-Natural Stone and Pavers. Marble, Travertine, Limestone, Granite, Slate, Concrete, Grout, Brick, Block. (Trial)

COLOR ENHANCER is water-based and low odor. It penetrates deep into hard surfaces enhancing the natural beauty of pavers, concrete, natural stone including marble, granite, slate, limestone, travertine, and masonry surfaces without adding significant gloss to the surface. (For surface gloss use our Wet Look Sealer) Our Color Enhancer is formulated to darken and highlight the character and beauty of unsealed surfaces. It rejuvenates the color and improves the appearance of worn and weathered stone. Allows moisture vapor transmission. It also effectively seals and darkens the color of grout joints. It is long-lasting, easy to apply, and is suitable for both interior and exterior use. Water vapor permeable but resistant to liquid water. ALWAYS TEST APPLICATION IN A SMALL AREA BEFORE PROCEEDING. Once treated, the surface cannot be restored back to original look. DIRECTIONS: ALWAYS TEST each type of surface for appearance and penetration before overall application. Surface must be clean and dry prior to application. Apply Color Enhancer to dry surface with a paint brush, roller, or low-pressure sprayer. Maintain surface dampness with Color Enhancer while the product is absorbing. After 10 minutes wipe entire surface with dry with a clean lint free towel replace towel with fresh, dry one as necessary. If a deeper color is desired, apply a second coat. For best results, the temperature of the substrate to be coated must be between 50 F- 85 F at the time of application. WASH hands and contaminated skin thoroughly after handling. Wear eye protection and rubber gloves when handling. COVERAGE: Approximately 100-400 sq. ft. per gallon depending on application method, porosity and surface texture.