Cover All: CrystaLac & Epoxy Tumbler Prep, (no more sanding or stripping your tumblers, pens, and more. Adheres to Sublimation, Stainless Steel, Powder Coated, Acrylic, Plastic, Glass, Ceramic, and more) 4oz.

Cover All: CrystaLac & Epoxy Tumbler Prep, (no more sanding or stripping your tumblers, pens, and more. Adheres to Sublimation, Stainless Steel, Powder Coated, Acrylic, Plastic, Glass, Ceramic, and more) 4oz.

• Environment: A temperature between 68ºF and 75ºF is ideal.
• Application: A dry, soft bristled brush works best. Use plenty of Cover All to get good coverage. If you see any repelling while it's wet, brush over it a few times until it fills in.
• Dry Time: Use 2 coats to ensure complete coverage. Ensure 2 hours of dry time between coats. A warm lamp hanging above it helps it to cure faster. You can also heat set Cover All by using a heat gun set on LOW, moving quickly and not too close. Be careful though, if you get it too hot, it can blister.
• Tinting: You can tint the Cover All by adding a few drops of our concentrated pigments and micas into it. Do this on the second coat. The first coat needs to be undiluted and pure for best adhesion.
• Curing: Cover All takes approximately 8 days before it becomes permanently adhered. No worries, you can still continue with your design 2 hours after the last coat. Cover All will continue to cure along with your other products as they dry. DO NOT pick or scratch off the Cover All while it is curing!