DFRobot Gravity: Analog Heart Rate Monitor Sensor (ECG) for

DFRobot Gravity: Analog Heart Rate Monitor Sensor (ECG) for Arduino
- The DFRobot Heart Rate Monitor Sensor is used to measure the electrical activity of the heart
- As this sensor can work at 3.3V which make it compatible with Raspberry Pi, Intel Edison, joule and curie
- NOTE: This product is NOT a medical device and is not intended to be used as such or as an accessory to such nor diagnose or treat any conditions
INTRODUCTION
The DFRobot Heart Rate Monitor Sensor is used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG and output as an analog reading. An ECG signal can be extremely noisy so we have included an AD8232 chip which will generate a clear signal from the PR and QT Intervals. Using the Arduino IDE "Serial Plotter" feature, you are also able to view plotted ECG output on PC!

To ease the difficult of using this sensor, a Gravity Interface is adapted to allow plug&play. The IO expansion shield is the best match for this sound senor connecting to your Arduino. As this sensor can work at 3.3V which make it compatible with Raspberry Pi, Intel Edison, joule and curie.

NOTE: This product is NOT a medical device and is not intended to be used as such or as an accessory to such nor diagnose or treat any conditions.

SPECIFICATION
Input Voltage: 3.3-6V (5V recommended)
Output Voltage: 0-3.3V
Interface: Analog
Operating current: <10mA
Dimension: 35 x 22(mm), 1.378" x 0.866"(in)
Interface Type: PH2.0-3P

SHIPPING LIST
Heart Rate Monitor Sensor x1
Sensor cable - Electrode Pads (3 connector) x1
Biomedical Sensor Pad x6
PH2.0-3P cable x1
Country USA
Brand DFROBOT
Manufacturer DFROBOT
Binding Health and Beauty
ItemPartNumber SEN0213
EANs 6959420910755
ReleaseDate 0000-00-00

Country	USA
Brand	DFROBOT
Manufacturer	DFROBOT
Binding	Health and Beauty
ItemPartNumber	SEN0213
EANs	6959420910755
ReleaseDate	0000-00-00

DFRobot Gravity: Analog Heart Rate Monitor Sensor (ECG) for Arduino

You might also like...