Power Tool Organizer, Drill Charging Station，Drill Holder Wall Mount, Power Too Holder Storage, Cordless Too Drill Organizer, Screwdriver Organizer, Wood Garage Wall Organizer, Drill Organizer Rack

Features:
♣ 2 sufficient storage space for placing tools and parts, and 5 hanging slots for electric drills
♣ The surface and edges of the board are polished,smooth and will not scratch your fingers
♣ 48 screws for multi-dimensional connection of product parts, sturdy and strong load-bearing capacity
♣ Our products are made of high-quality hard wood and surface treatment technology, which makes the product moisture-proof, anti-erosion, strong and durable.
Specifications:
Material:high-quality wood
Color: Yellow
Size:19.5in/495mm x 8.3in/210mm x 12.2in/310mm Product parts and installation steps
A x 4 ; B x 4 ; C x 1 ; D x 1; E x 1 ; F x 1 ; G x 1 ; H x 2; I x 40 ; J x 4 ; K x 4 Step 1
Find the A and B plates, the B plates are placed horizontally, the A plates are placed vertically, and the two plates are locked with I. In the same way, four A plates and four B plates are assembled.
Step 2
Take out the C board,The two screw holes above the A board are aligned with the two screw holes of the C board and tightened with I.
Step 3
Align the back of the above installed module with the 6 holes in the lower part of the D plate and tighten with I .
Step 4
Place the E-plate horizontally and align the two screw holes in the middle of the D-plate and tighten with I. Assembled into new modules.
Step 5
Take out the G plate and the F plate, connect the H plate to the bottom of the G plate (without the side of the wire slot).Connect the H plate to the bottom of the F plate with I, and keep the two H plates in opposite directions.
Step 6
Install the G and F plates on the left and right sides of the new module respectively, and tighten them with I .
Step 7
Hold the D plate against the wall, align the 4 holes of the D board and use J to drive into the wall. Then use K through t