Heavy-Duty Electric Recovery Winch - 17,000 lbs. Capacity - Driver Recovery Products

Premium electric winch from Driver Recovery Products; rated for single-line pull up to 17,000 pounds. An upgraded direct-current (12-volt DC) motor delivers maximum torque. The series-wound motor allows consistent power through the duty cycle as opposed to magnet motors that may falter when they heat up. The motor is reversible so the cable can be wound out or in. Components of the three-stage planetary gear system are precisely manufactured for efficient, smooth operation to eliminate slippage and wear. A lever on top of the winch allows easy engaging and disengaging from the drum. When disengaged, the drum will freespool, meaning the rope can be pulled without the motor. When engaged, the drum is secured to the motor using a sliding ring gear clutch. An automatic breaking system locks the rope in place to hold the load when power is not applied. The rope is extremely durable, abrasion-resistant 1/2" aircraft-quality wire (85') wrapped around a 3-1/2" diameter x 8-11/16" long drum. Roller fairleads use wave washers and c-clips to secure the rollers, and dowel-pin bearings and composite bushings on multi-directional rollers mean smooth operation at extreme angles. A hand held wired remote control with 12' cord allows the line-out and line-in controls to be operated at a distance. The winch is easy to install; just mount the winch, connect the power, and ground. It measures 22" x 7-1/2" x 10-1/2" high, and weighs 125 pounds. Industry standard 10" x 4-1/2" mounting bolt pattern. Included is the LD17-PRO winch, 85' of pre-wound 1/2" cable, premium roller fairlead, wired controller (12' cord), 1/2" clevis slip hook with latch (grade 70), hook safety pull strap, owner's manual, mounting hardware, 72" power wire (0 gauge red, pre-attached), and 72" ground wire (0 gauge black).