E3D Genuine 24V, RapidChange™ Revo Micro, 1.75mm Fully Loaded HotEnd Kit, for 3D Priniting. Brass Nozzles Sizes Included - 0.25mm 0.4mm 0.6mm 0.8mm.

E3D Genuine 24V, RapidChange™ Revo Micro, 1.75mm Fully Loaded HotEnd Kit, for 3D Priniting. Brass Nozzles Sizes Included - 0.25mm 0.4mm 0.6mm 0.8mm.

• Ready for Revo. Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are a factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use.
• New hotness. A Revo HeaterCore heats up in seconds. It’s much safer too – unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.
• Runs cool, looks cool. With an anodised black heatsink, not only does Revo Micro run cool – it looks cool, too.
• Flexible to any setup. Revo Micro plays nice with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups.