G-Works Gas Saver Plus Upgrade Cartridge Exchanger Anodize

G-Works Gas Saver Plus Upgrade Cartridge Exchanger Anodize Duralumin
- Gas Saver Plus Upgrade Cartridge Exchanger Anodize Duralumin
Usage / Notice
1. Be sure to check the valve lock before assembling the gas container, and use it in a safe outdoor location where there is no fire.
2. Tighten the gas container you want to use based on the printing direction, and assemble the gas container with the remaining amount on the upper part.
The gas container at the bottom should have enough free space to accept the gas being transported.
3. If you put the gas container located at the lower part in the freezer for about 10 ~ 20 minutes, it will be cooled and the internal pressure and volume will be smaller than the remaining gas container. (The freezer and cooler can be used for easy operation without any additional vaporization.)
4. If the forced pressure difference cannot be made, close the valve and press the gas discharge button for 4 to 5 seconds to change the pressure of the lower vessel to the normal pressure and open the valve again. (When using the eject button, it is effective to have enough free space in the container located at the bottom)
5. If the remaining amount of columnar gas container is moved, tilt it more than 45 degrees so that the groove part which is connected with the adapter is facing downward.
6. When removing the gas container, separate it with the outlet of the container facing upward. (When disconnected in the upside down position, the minute leakage may increase)
7. Check the overcharge state by measuring the weight of the gas container after moving. There must be shaking.

The ideal filling amount is about 80% of the container capacity. Check the state of overcharging, and when filling it with no shaking, move the gas to the empty container in reverse, so that there is about 20% of the capacity of the container.

Country USA
Brand G-WORKS
Manufacturer FBA_G-Works
Binding Kitchen
ItemPartNumber FBA_Gas Saver Plus
Model FBA_Gas Saver Plus
UPCs 634324604417
EANs 0634324604417
ReleaseDate 0000-00-00

Country	USA
Brand	G-WORKS
Manufacturer	FBA_G-Works
Binding	Kitchen
ItemPartNumber	FBA_Gas Saver Plus
Model	FBA_Gas Saver Plus
UPCs	634324604417
EANs	0634324604417
ReleaseDate	0000-00-00

G-Works Gas Saver Plus Upgrade Cartridge Exchanger Anodize Duralumin

You might also like...