Choose safety first with our CSA and ETL certified constant wattage pipe heating cable. These certifications guarantee top-notch safety standards. Protect your pipes and equipment from overheating and short circuits while reducing fire risks. Count on us for high-quality, certified solutions. Buy now for peace of mind.
𝙐𝙨𝙚 𝙛𝙤𝙧 𝙬𝙖𝙩𝙚𝙧 𝙛𝙞𝙡𝙡𝙚𝙙 𝙥𝙡𝙖𝙨𝙩𝙞𝙘 (𝙞𝙣𝙘𝙡𝙪𝙙𝙞𝙣𝙜 𝙋𝙀𝙓) 𝙤𝙧 𝙢𝙚𝙩𝙖𝙡 𝙥𝙞𝙥𝙚𝙨. 𝙉𝙤𝙩 𝙪𝙨𝙚 𝙛𝙤𝙧 𝙖𝙣𝙮𝙩𝙝𝙞𝙣𝙜 𝙚𝙡𝙨𝙚, 𝙡𝙞𝙠𝙚 𝙚𝙢𝙥𝙩𝙮 𝙬𝙖𝙩𝙚𝙧 𝙥𝙞𝙥𝙚𝙨, 𝙛𝙪𝙚𝙡 𝙡𝙞𝙣𝙚𝙨, 𝙝𝙤𝙨𝙚𝙨, 𝙜𝙪𝙩𝙩𝙚𝙧𝙨, 𝙨𝙩𝙚𝙖𝙢 𝙡𝙞𝙣𝙚𝙨 𝙖𝙣𝙙 𝙨𝙤 𝙤𝙣. Two-year limited quality . If you are not completely satisfied with HEATIT heating cable, please don't hesitate to contact our customer service at any time, we'll try our best to solve your issues.
Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket.
Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight. This product is backed by up to USD 2 million in product liability insurance, providing you with added peace of mind and security in your purchase.
Testing the cable before the installation. Uncoil the cable, plug in the heat tape for water pipes and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off.