Harley Davidson Twin Cam 88 TC88 (1999-2006) Inner Cam Bearing (B148) Installer and Puller Set

Set of Inner Cam Bearing Puller and Installation Tools. Designed for Twin Cam and Dyna models. Will work on all TC88 that use the B148 (AKA I.D. 0.88") bearings. Will NOT work on 2006 Dyna models. They use the larger 1.00" bearings (B168), and require the same tool as the newer (2007+) bikes. This set will remove and install the inner cam bearings on the older model Twin Cams and Dyna Harleys. We also have new Torrington-Koyo B-148 bearings available in our store! This set includes our Improved collet design. The design sold by others has the whole back of the collet threaded with two slots cut into the threads for turning a wrench on. It's simple, it's cheap, and it's bad. Use that design once or twice, and you may damage the threads where the wrench makes contact, requiring you to now clean up those threads before you can even get the nut off the collet and use it again. We've worked around this issue by moving the threads up on the collet and adding a 15mm full hex at the end to allow for a more controlled grip and protection of threads. We've also completely redesigned the installer plate, zeroing in on the correct hole placement by taking apart an engine and putting it on a digital drafting table to get the precise placement of all of the important dimensions. This set also includes our Patent Pending window modification to the installer plate. You paid too much for the bike and the tools to end up cracking the engine case because you can't see the bearing! With the redesign, you will never again have to squint through a tiny hole with a flash light!