JWGJW 166 High Pressure Washer Gun Snow Foam Lance Cannon Foam and M22 Thread Adapter （15mm-14mm） and A Water Nozzle

Package Include：
1x Pressure Washer Gun (M22-14mm Thread)
1x Foam Lance (1Litre)
1x Nozzle tip (0 angle degree)
1xM22 adapter(15 mm Thread Conversion 14mm Thread)

Note:
M22 adapter (thread). Only when the pipe connector's type
is M22-15MM, you need to install it. It's a complimentary product.

Specifications:
Material:brass+ABS
Interface: G1 / 4 "-F
Max Pressure: 3000PSI
Rated pressure:1000PSI
Maximum Pressure: 3000PSI
Maximum flow: 5.3GPM
Max Temperature: 60℃ / 140℉
Bottle Capacity: 1L

Description:
â—† A top pressure of 3000 psi makes quick work of stubborn stains, while
a maximum temperature of 60 degrees Celsius cuts through grime
with ease.
â—† Designed to be specially used with Snow Foam chemicals it really
does provide the best pre-wash method for your vehicle. Simply add an
inch of your snow foam chemical into your 1 Litre bottle, top it off with warm
water and begin snow foaming.
It really is that simple! Allow the foam to dwell for 5 minutes and then
blast off with your pressure washer removing away the road grime
and dirt, you can then begin your two bucket method wash safely!

Some tips for using the foam gun correctly :
a. Fill the bottle with hot/warm water before adding soap.
This helps your solution mix together.
b. Adjust the spray nozzle first to find the stream of water that works for you.
You can adjust it so that it sprays in a decent fan pattern.
c. Adjust the knob on the top to control how much water is mixed in.
d. DO NOT max out the knob onto the (-) side otherwise you wont get much foam.
You can turn it all the way to the (-) then dial it back a little,
this produced a ton of foam.