MakerFocus ESP32 OLED WiFi Kit V3 Integrated WiFi Bluetooth

MakerFocus ESP32 OLED WiFi Kit V3 Integrated WiFi Bluetooth CP2102 IoT Development Board with 0.96-inch OLED Display for Arduino Intelligent Scenes
- Support Arduino Development Environment: WiFi kit 32 is a classic IoT Dev-board, it’s a highly integrated development board based on ESP32 (Including WiFi and BLE), fully support Arduino development environment
- Easy to Use: With good RF circuit and low-power design, ESP32 development board is the best choice for smart cities, farms, homes and IoT makers
- Perfect Circuit Design: Onboard WiFi, Bluetooth 2.4GHz PCB antenna. Integrated CP2102 USB to serial port chip, convenient for program downloading, debugging information printing
- Power Supply: Onboard SH1.25 battery interface, integrated lithium battery management system. You can also use the Type-C interface to power the development board
- OLED Display: Onboard 0.96-inch 128*64 dot matrix OLED display, which can be used to display debugging information, battery power and other information
Description:
WIFI Kit series is the new development of the cost-effective networking program, the main chip using Lexin ESP32, Tensilica LX6 dual-core processor, 240MHz, computing power up to 600DMIPS, chip built-in 520 KB SRAM, 802.11 b / g / N HT40 Wi-Fi transceiver, baseband, protocol stack and LWIP, integrated dual-mode Bluetooth (traditional Bluetooth and BLE low power Bluetooth).
Onboard 8MByte(64M-bit) Flash, Wi-Fi antenna, 0.96-inch blue OLED display, lithium battery charging circuit and interface, CP2102 USB to serial chip, the perfect support for Arduino development environment

Specification:
Operating voltage: 3.3V to 7V
Operating temperature range: -40 ° C to + 90 ° C
Data rate: 150 Mbps 11n HT40,72 Mbps 11n HT20,54 Mbps 11g, 11 Mbps 11b
Transmit power: 19.5 dBm 11b, 16.5 dBm 11g, 15.5 dBm 11n
Flash Size: 8MByte(64M-bit)
Module Size:50*25.4*10.3 mm
Lithium battery interface:2Pin-1.25mm interface
Receiver sensitivity up to - 98 dBm
UDP continues to throughput by 135 Mbps
Supports Sniffer, Station, softAP and Wi-Fi Direct modes

Package Including
1 * ESP32 Development Board with OLED
2 * Pin headers
Country USA
Brand MakerFocus
Manufacturer MakerFocus
Binding Personal Computers
ItemPartNumber UZM173505AEVXI378
Model 8541612336
UPCs 190033879688
EANs 0190033879688
ReleaseDate 0000-00-00

Country	USA
Brand	MakerFocus
Manufacturer	MakerFocus
Binding	Personal Computers
ItemPartNumber	UZM173505AEVXI378
Model	8541612336
UPCs	190033879688
EANs	0190033879688
ReleaseDate	0000-00-00

MakerFocus ESP32 OLED WiFi Kit V3 Integrated WiFi Bluetooth CP2102 IoT Development Board with 0.96-inch OLED Display for Arduino Intelligent Scenes

You might also like...