Midwest Hearth Universal Gas Log Lighter Starter for Wood

Midwest Hearth Universal Gas Log Lighter Starter for Wood Burning Fireplaces ((NG) - Natural Gas)
- STRAIGHT OR ANGLED - Can be easily converted for either a straight or 90 degree angled installation.
- AIR/FUEL MIXER - Shutter attached to the air-gas mixing chamber adjusts the flame from golden radiant to hot blue for a hotter fire.
- HEAVY DUTY - Sturdy construction provides years of reliable service.
- THIS DEVICE IS INTENDED ONLY FOR STARTING A WOOD FIRE AND IS NOT TO BE USED AS A DECORATIVE GAS APPLIANCE OR AS A SPACE HEATER
- CLEAN AND EFFICIENT - Can reduce emissions from wood-burning fireplaces by 50%.
INSTALLATION TIPS

A listed gas valve (not included) must be installed upstream of the log lighter.
The log lighter should be located such that the burner ports are horizontal, facing into the fire box, with the air shutter facing out toward the front
Locate lighter to minimize flame impingement on the grate.
Adjust the air shutter to give a sharp blue flame with yellow tips.

LIGHTING/OPERATION

• Make sure chimney flue and glass doors and screens are open.
• Fireplace should be clean of debris, as this could contain hot coals which could cause ignition if not disposed of properly. Ashes should be placed in a metal container with a tight fitting lid. The closed container should be placed on a non-combustible floor, and kept away from other combustible materials until the ashes have cooled.
• Make sure the log lighter gas valve is in the OFF position.
• Stack logs on the fireplace grate allowing an air space between the logs for quick lighting. Wait approximately five minutes before lighting.
• Make sure that shutter on mixing chamber is open to ensure that air and gas is being mixed. Flame should be blue.
• Light the burner by using a long fireplace match or lit paper under the center of the lighter near the burner ports.
• Turn the gas valve ON gradually until burner ignition occurs.
• If burner does not light within 5 seconds, turn valve off and wait 5 minutes before trying to relight.
• When log lighter is burning, close the fireplace screen. Do not close glass doors unless the wood in fireplace has been certified for use with log lighter with doors closed.
• When the wood fire is lit, the log lighter valve should be turned off. Failing to do so will cause wood to burn faster than normal. Remove gas valve key and place in a safe location.
Country USA
Brand Midwest Hearth
Manufacturer Midwest Hearth
Binding Kitchen
ItemPartNumber MH Log Lighter
Model MH Log Lighter
Color Gray
UPCs 645360706751
EANs 0645360706751
ReleaseDate 0000-00-00

Country	USA
Brand	Midwest Hearth
Manufacturer	Midwest Hearth
Binding	Kitchen
ItemPartNumber	MH Log Lighter
Model	MH Log Lighter
Color	Gray
UPCs	645360706751
EANs	0645360706751
ReleaseDate	0000-00-00

Midwest Hearth Universal Gas Log Lighter Starter for Wood Burning Fireplaces ((NG) - Natural Gas)

You might also like...