Lightweight, military grade polymer shot shell carrier kit.
Mounted to Mossberg shot gun for easy access and fast reload.
Easy installation, shotgun shell pouch is accompanied with all the required mounting screws.
Widely used in training, competition, or hunting, and so on.
Polymer shot shell carrier fit Mossberg 500, 590, 590DA 590A1, only holds 6-round 12GA shots.
FEATURES:
· Lightweight, polymer shotshell carrier. · Easy installation, requires no alterations to the shotgun in most cases. · All mounting screws are included, no gunsmithing required.
INSTALLATION GUIDE:
1.Remove 6 little hex screws from the shotshell carrier to expose two tapped hole in the mounting plate. 2.Lay the shotgun on its side with the ejection port facing down. 3.Using the supplied big screw with washer, push out pin (A) located above and to the rear of the trigger guard. Leave screw in hole. 4.Turn the shotgun over and place the mounting plate on the receiver with the two corresponding holes on the two screws. 5.Start screws into the mounting plate and lightly tighten. Do not overtighten. Overtightening may lock up the shotgun's action. To remedy, simply loosen screws.