The Optilux fog beam pattern is designed to work with your factory headlamps to provide the best possible visibility
Clear rectangular lens inside of a stylish die-cast black metal housing
Increase driver safety and comfort with less eye fatigue under year-round weather conditions including fog, rain, dust, or snow
Optilux auxiliary lamp kits come with 2 lamps, 2 bulbs, wiring harness and mounting instructions
One Year Limited Warranty
These Optilux fog lamps create a fog beam pattern that's designed to work with your factory headlamps to provide the best possible visibility, increasing driver safety and comfort. This model features a clear rectangular lens inside of a stylish die-cast black metal housing. Each kit contains two lamps, two 12V/55W H3 halogen bulbs, heavy-duty mounting brackets, switch and a deluxe wiring harness.
Hella limited warranty guarantees Hella products to be free from defects in materials and workmanship for the period of one (1) year after retail purchase from an authorized Hella dealer. This guarantee does not cover damages from road hazards, improper wiring, installation or operation, or willful abuse. Warranty does not cover consequential damage, or damage or inconvenience caused by non-operation of the product. Hella's liability is limited to either free repair or free replacement of warrantied merchandise at Hella's discretion. No credits or refunds will be issued. Prove of purchase required. No warranty or guarantee, expressed or implied, exists with regard to standard bulbs.
Most Helpful Customer Reviews
I've had a set of these lamps on my truck for over a year. The Optilux 1450 compare favorably to OEM and mid-range PIAA or Hella lamps. These are true "fog lamps" that project a wide, flat beam. There is a clean cut-off of light at the top of the pattern, making it possible to use these lights with oncoming traffic with the shield removed, if they're properly aimed.
You can significantly improve the performance of these lights by removing the shield from the bulb. The shield is there to prevent poorly-aimed lights from blinding oncoming drivers. If you know how to properly mount and aim fog lamps you should remove the shield. If you are the type of person who doesn't fuss over the fine points such as careful aiming and maintenance, please leave the shield in place.
Remember that they are supposed to be aimed low to fill in the gap under your regular lights. They are not distance lights, and by themselves fog lamps don't provide a whole lot of light. Properly...
Thanks to everyone's reviews, I decided on these lights. These are really good fog lights, to my surprise, and they will be replacing a pair of HELLA MicroDE fog lights that have started to corrode badly. The light pattern is very wide and bright. As for the removing of the shield, I did a side by side comparison to see what the difference was between the standard and the light with the shield removed. I honestly did not see much light variance side by side. On the other hand, looking at the shield-less light when lit, was not as tolerable vs. the shielded light and this could be a bother to opposing traffic. I also noticed that the housing on the shield-less light got hotter faster than the light with the shield on. They were both on for about 2 minutes at the same time and the shielded light was warm to the touch while the non shielded light was really hot. Based on my observation, I think I will leave the shields on since they seem to absorb some of the radiating heat from the...
For this budget you can beat them. They give decent output. They cover the spot before the bumper that is left out by headlights. Try to place it as close to the ground and on either ends of bumper for maximum efficiency. Do not remove the black housing that is covering the bulb as it is there to preventing these lights from blinding on coming traffic. These come with all hardware and even diagram. It has relay and fuses as well so chances of electric fire is small/nil. construction looks very good as well. my only complain is there seem to be some water going into the housing during car washes. But its been a year and none of the bulbs are gone. So I guess the water entering is small enough not to cause a short. I really love them. Cant ask more from a $35 bumper lights.
The authorised South African distributor of this product is under no obligation to honour the manufacture's guarantees/warranties or to provide after-sales service.
Please note that this item is imported from the USA, and is designed to be used in the USA. In addition, if the unit is powered it will come with a US plug and an adapter/transformer may be required. Please click here for more information on power requirements, or check with us if you are unsure or need any assistance!
Please also note that certain items cannot be imported, these include Alcohol, Animals, Batteries, Flammable Materials, Currency, Food, Furs, Chemicals, Explosives, Medications, Plants, Seeds, Supplements, Pressurized Cans, Tactical Equipment, Vitamins, Weaponry and Weaponry Accessories. In these cases, the item and information is displayed for reference purposes only. If you are not sure if we are permitted to bring an item, please send us an e-mail with a link to the item to confirm.
Please also ensure that you are ordering the correct item for your particular application as returns to the USA are costly. Product reviews are also provided for most of our items, which can give you a good idea for possible things to look out for and the quality of the item. By clicking Add to Cart, you are confirming that the item is correct and you accept the conditions listed here.