5PCS 0.96 Inch OLED Display Module, PEMENOL 128 x 64 Pixel I2C

5PCS 0.96 Inch OLED Display Module, PEMENOL 128 x 64 Pixel I2C IIC Serial 1 OLED LCD Display Module with SSD1306 Driver for Arduino Raspberry Pi and ESP8266（White Light）
- 【CHANGEABLE IIC ADDRESS】: The built-in standard driver chip SSD 1306 already exists in the libraries of Raspberry Pi and 51 Series,which makes programming very easy. This oled display can be used with different machine easily.
- 【128 X 64 PIXELS】: With high resolution of 128 x 64 pixels, no need backlight, self-illumination, pixels stand outvery well even in a brighter circumstances like full sunlight.
- 【COMPATIBLE WITH MANY CONTROL CHIPS】: This oled display can be widely use with 51 series, MSP430 series, STM32/2, CSR IC, etc. 4PCS male pins makes the lightweight connecting easily.
- 【WIDE FIELD OF CLEAR VIEW】: 0.96inch OLED display module supports 180 degrees of view from up to down and right and left, which is convenient for you to clearly observe the information displayed from different angle.
- 【EASY TO INSTALL】: With four square holes, our I2C OLED display module can be installed easily, truly convenient to use and simple you working.
PEMENOL 5PCS OLED Display Module can be wide use widely use with arduino, 51 series, MSP430 series, STM32/2, CSR IC, etc. With 128 x 64 pixels high resolution, no need backlight and self-illumination, providing 180 degree clear display. High contrast through the use of innovative OLED technology in the large 0.96 inch display!

Specifications:
- Color: white light
- Driver chip: SSD1306
- Interface Type: IIC / I2C-4PIN
- High Resolution: 128 * 64 Pixels
- Voltage: 3 V ~ 5 V DC
- Viewing Angle: almost 180 degrees
- Low power consumption : Full Screen 0.08 w
- Operating Temperature: -30 Celsius ~ 70 Celsius
- Many Control Chip Supports: Fully compatible with Arduino, 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc

Pin Definition:
- GND: OLED Power Ground
- VCC: OLED Power Positive 3.3-5 V
- SCL: OLED IIC Clock
- SDA: OLED IIC Data Line

Note: OLED is self-luminous, no backlight needed! It does not respond when you just connect it to the mains, you have to program it and work properly, then it will display normally.

Country USA
Brand PEMENOL
Manufacturer PEMENOL
Binding Personal Computers
ItemPartNumber 9924
Model 9924
Size 5 Piece
UPCs 613635854063
EANs 0613635854063
ReleaseDate 0000-00-00

Country	USA
Brand	PEMENOL
Manufacturer	PEMENOL
Binding	Personal Computers
ItemPartNumber	9924
Model	9924
Size	5 Piece
UPCs	613635854063
EANs	0613635854063
ReleaseDate	0000-00-00

5PCS 0.96 Inch OLED Display Module, PEMENOL 128 x 64 Pixel I2C IIC Serial 1 OLED LCD Display Module with SSD1306 Driver for Arduino Raspberry Pi and ESP8266（White Light）

You might also like...