Revolution Electronics Electric Fuel Pump Controller. Primes

Revolution Electronics Electric Fuel Pump Controller. Primes the pump on key-on and turns the pump off if the engine stops.
- Monitors the tach signal - as long as there is a tach signal present, the pump is allowed to operate. If the engine stops, so does the fuel pump. Works with both inductive (stock) and square-wave (aftermarket) tach signals. For vehicles without a tach, connect to the negative side of the coil.
- Turns on an electric fuel pump for 3 seconds on initial key-on. This primes the fuel system and tops off the carburetor's fuel bowls.
- Controls an electric fuel pump when a classic car or truck is upgraded from a mechanical fuel pump.
- Includes an internal self-resetting 7 amp fuse and 15 feet of 16 gauge wire to connect the fuel pump. Higher amperage pumps can be controlled by adding an external relay.
- For 12V vehicles. 2 by 1.5 by 1 inches. Fully potted.
- Made in USA
Designed to safely control an electric fuel pump when a classic vehicle is upgraded from a mechanical fuel pump to an electric fuel pump. Powers the pump for three seconds on initial power-on to fill the carburetor bowls. After those first three seconds, the pump will only run if there is a tach signal. If the tach signal stops, the pump shuts off. Includes an internal 7A self-resetting fuse, 15 feet of 16 gauge wire, and the necessary hardware for most installations.
Country USA
Brand Revolution Electronics
Manufacturer Revolution Electronics
ItemPartNumber 12003
ReleaseDate 0000-00-00

Country	USA
Brand	Revolution Electronics
Manufacturer	Revolution Electronics
ItemPartNumber	12003
ReleaseDate	0000-00-00

Revolution Electronics Electric Fuel Pump Controller. Primes the pump on key-on and turns the pump off if the engine stops.

You might also like...