RingSlinky Ring Guard / Ring Size Reducer (3.0mm Ring Shank Width)

RingSlinky is the first of its kind: a ring size reducer made of coiled nylon.

Traditional metal ring guards often scratch the surface of the ring and are best installed by a jeweler with professional grade tools. Plastic ring guards often retain moisture, discolor with time, and have a tendency to fall off of your ring. RingSlinkys however, are clear, hypoallergenic, do not require tools for installation, do not damage rings or retain moisture, and stay perfectly installed on your rings until you want to remove them.

RingSlinkys come in 3-packs, and are available in six sizes based on the width of your ring shank: 1.5mm, 2.0mm, 3.0mm, 4.0mm, 5.0mm, 6.0mm. These sizes are based on the width of the ring, not the ring size.

All RingSlinky sizes reduce the ring size up to approximately 1 1/2 ring sizes, but can be cut shorter using scissors or a utility knife to decrease the amount of size reduction if the ring fits too tightly.

It is important for the RingSlinky to fit your ring snugly for best results.

Please measure the width of the bottom of your ring with the MM (metric) side of a ruler, then choose the size RingSlinky that is slightly smaller than your ring's measurements.

To install RingSlinky, simply slip one end over the ring and twist it further onto the ring. To uninstall, simply pull one end and unscrew it from around the ring.

PGC INC is the manufacturer and ONLY AUTHORIZED SELLER of this product. Purchases from any other seller will not have our customer service or exchange privileges and may not be in approved packaging.

US Patent Pending. COPYRIGHT 2016 PGC INC - ALL RIGHTS RESERVED