TEMO 10 pc 1/2 Inch Rubber Mandrel Sand Drum Holder 1/8 Inch Shank for Dremel Rotary Tools

• 10 pc 1/2" (12.7mm) Rubber Mandrel 1/8" inch Shank Sand Drum Holder Dremel Rotary tool
• 10 piece 1/2" (12.7mm) X 1/2" (12.7mm) Rubber Mandrels; used to hold sand drum or sand band; 1/8" (3.175mm) shank size fit Dremel and other Rotary Tools
• Here are our best practices for using sand drums. 1. Adjusting the screw at the top of the mandrel will loosen or tighten the sand drum. Make sure the sand drum is held tight to the mandrel before use.
• 2. During use, periodically power down the rotary tool to check the sand drum. Ensure that there is sufficient grit remaining on the band before continuing.
• 3. Rotary tools can operate at very high RPM. High RPM with a small tool such as a sanding drum produces a lot of friction and heat build up. Ensure that your sand drum and mandrel is not getting too hot. Consider using medium speed and alternating mandrels as you change sand drums out to reduce heat build up.
  4. Rotary tools are power tools. Always consider appropriate eyewear and other PPE to suit your task.

TEMO is a registered trademark of Golden Coulee, LLC and Golden Coulee is the sole authorized seller of TEMO brand products. Counterfeit products may be unsafe, not made to the correct safety standards, and may be of poor quality. Golden Coulee reserves the right to pursue unauthorized use of the TEMO trademark to the fullest extent of the law.