[Upgrade PIR Sensor]HKYH 4 Pack Solar Motion Sensor Security Light, Solar Powered Fence Gutter Light, Super Bright 4 LED Solar Light, Security Light for Door, Pathways, Patios and Garden
Sold Out / Out of Stock
This item may be available in a different size, colour, scent, version or platform:
[Upgrade PIR Sensor]HKYH 4 Pack Solar Motion Sensor Security Light, Solar Powered Fence Gutter Light, Super Bright 4 LED Solar Light, Security Light for Door, Pathways, Patios and Garden
Smart Motion Sensor:HKYH LED solar lights will automatically turns on at night when motion is detected. Activates bright light when inside the 6-8 meters activation zone.In this distance,HKYH solar lights is super brighten.If you keep in this distance,it will last for 45 seconds and turn into energy conservation modes.
Solar Panels:HKYH Led night light is made up by 8 high-efficiency mono-crystalline panels that can efficiently transforms solar energy into electrical energy by assimilating sunlight. Only 4.5 hours,it'll fully charged and work for more than 8-12 hours.
Energy saving and help you save money:No batteries, no cables, No electricity cost. Recharged by solar panel under sunlight, and no battery replacement.
Height of Solar Fence Light: with 60 times motion in one night. and full light 150LM when motion,and 15Lm without motion which means in energy saving modes.
Weathproof and Powerful LED solar outdoor light:waterproof and heatproof,Made by high glisten rate of anti reflector cover,it'll make full utility of solar power,tightly-sealed loop in order to be more wheatherproof, antifog and anti-mosquito.
Specifications:
Item Size:12x12x5cm Solar Panel: Polycrystalline 0.8W Battery: Rechargeable 3.7V/750mAh/Li-ion Light Source:4pcsxSMD5730#,0.5/led,150LM/15LM First time use: Remove the protective film from the solar panel before the first use. Turn the switch to ON position, and place the lamp under sunshine for at least 3 to 4 hours before first time use.(The power of lamp may run out during the long time transportation.)
Instruction: This units has intelligent light control switch, automatic control products daily work, when the ray of light is more than 100 LUX, solar panels will charge the battery, and when the night falls or ray of light is lower than 100 LUX, this lamp will automatic light, no need human operate any more.
1.Turn the switch to ON position. The switch is located at the bottom base of the solar panel. Charge the solar product by placing it under direct sunshine for at least 4 hours. 2.The light will work automatically once the switch is on ON position. It will automatically charge under direct sunshine in the day time and illumination at night. Note: In order to verify that knob is correctly switched to ON position. Cover the solar panel with your hand and the light will turn ON automatically. 3.It has human body induction motion sensor with lee than 60 times one night, after the induction it gives full light, each 45 seconds later, it turns to energy saving mode.(the induction distant is 6-8M,induction angle is 90 for full light)
Important: 1.Installation the solar product in an area where it can get direct sunlight. 2.Select an outdoor location away from other light source at night such as street lights,It may cause the product not to turn on automatically at night.