for Ryobi 18v JUMP STARTER, for Jump starting Cars Trucks

for Ryobi 18v JUMP STARTER, for Jump starting Cars Trucks Tractors (Battery is NOT INCLUDED)
- Can start any 12v battery system, overcharge protection, great for start your vehicle in emergencies, this pack will only work when battery is approximately 2 volts or greater. This will not work on a completely dead battery
- Designed for jump starting nearly dead batteries in Cars, Trucks, Boats, Tractors, Mowers, ATV’s and anything that starts with a conventional lead acid 12V battery
- Insert a fully charged battery into the adapter and subsequently connect the unit to the defective vehicle battery. The red clamp is connected to positive + and the black clamp is connected to negative -. Turn the switch on and allow the battery to charge for approximately 30 seconds to 1 minute then turn the switch off. Attempt to start the vehicle, if the vehicle does not start, follow the same steps to charge again. Disconnect the clamp within 30 seconds after starting the vehicle
- Please use caution and connect exactly as instructed, disconnect the cable immediately after starting to prevent overheating. If the vehicle fails to start, wait a few minutes and try again
- Safe and reliable: ABS plastic adapters, PVC insulated cables and copper clamps with nylon housings ensure maximum safety and long-lasting durability during use
Country USA
Brand motoparty
Manufacturer motoparty
Binding Automotive
ItemPartNumber MTP-F99W1025ABG2
Model MTP-F99W1025ABG2
Size High
UnitCount 1
ReleaseDate 0000-00-00

Country	USA
Brand	motoparty
Manufacturer	motoparty
Binding	Automotive
ItemPartNumber	MTP-F99W1025ABG2
Model	MTP-F99W1025ABG2
Size	High
UnitCount	1
ReleaseDate	0000-00-00

for Ryobi 18v JUMP STARTER, for Jump starting Cars Trucks Tractors (Battery is NOT INCLUDED)

Customers who purchased this also purchased....